Introduction & Description; Introduction; Description - Bush Hog TD-1100 Operator's Manual

INTRODUCTION AND DESCRIPTION

1-1 INTRODUCTION

We are pleased to have you as a Bush Hog cus-
tomer. Your TD-1100 Finishing Mower has been
carefully designed to give maximum service with
minimum down time. This manual is provided to give
you the necessary operating and maintenance
instructions for keeping your mower in top operating
condition. Please read this manual thoroughly.
Understand what each control is for and how to use
it. Observe all safety precautions decaled on the
machine and noted throughout the manual for safe
operation of implement. If any assistance or addi-
tional information is needed, contact your authorized
Bush Hog distributor.
All references made to right, left, front, rear, top or
bottom are as viewed facing the direction of travel
with implement properly attached to tractor.
Figure 1-1 TD-1100
SECTION I
NOTE
Technical Specifications
Specification
Cutting Width
Transport Width
Cutting Height
Blade Tip Speed (FPM)
Required Tractor Horsepower
Wing Flex
Belts
Driveline Size

1-2 DESCRIPTION

The TD-1100, Figure 1-1, is designed for turf main-
tenance applications where a high quality of cut on
turf grasses is required.
The caster wheel arrangement along with the flexi-
ble, floating deck attachment and the standard front
mounted rollers, all work together to give an even
cut and minimize scalping.
NOTE: The inside rear wheel on the wing mower
decks and both the front wheels on the rear mower
deck are rigidly mounted and are not designed to
caster.
Power from the tractor is transmitted through a
telescoping driveline to a belt drive and gearbox
arrangement which allows either wing unit to be fold-
ed up to 30° while still operating. Power is passed to
the spindle housings by a B-section, Kevlar reinforced
belt. Drivetrain protection is provided by belt slip-
page.
TD-1100
11'
78"
3/4 to 4-1/2"
16,100 FPM
30 HP min.
30° up, 10° down
Kevlar
Cat. IV 80° CV (main),
Cat. III (wing)
6