GE Advantium CWB713 Installation Instructions Manual page 11

Preparation
• PSB9120 and PWB7030 are the only approved models to be installed under 36-3/4" height with a
storage drawer. CSB9120, ZSC1201, ZSC1202 and CWB7030 are not approved.
• As needed, see the Standard Mount Installation Preparation OR Flush Mount Installation Preparation
for configuration details. Note the modified cutout height below.
• Model ZSC1202 cannot be installed with an accessory storage drawer. See installation preparation
without an accessory storage drawer for this model.
PREPARE THE OPENING (cont.)
The Advantium/Convection 120V can be installed in combination with other Built-In appliances. Always follow each
product's Installation Instructions to complete the installation.
Single Advantium/Convection 120V Installation:
Order a 30 wide single oven cabinet or cut the opening in a wall to the dimensions shown.
STANDARD MOUNT
30
25-1/4
Min.
21
36-3/4
Min.
• For flush installation, make the bottom cleat height 3/4" when installed over a storage drawer.
the side edges, and 3/4" from the bottom. (Note: these refer to minimum clearances required for installation and do
not reflect actual product dimensions.)
• Oven overlaps will conceal cut edges on all sides of the opening.
• When installed over a single oven or a warming drawer, allow at least 2 between the two openings. This separation
will provide clearance for bottom overlap of the Advantium/Convection 120V and the other appliance overlaps.
• The support must be level and rigidly mounted, flush with the bottom edge of the cutout.
Installation Preparation
WITH
23-1/2
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
an Accessory Storage Drawer
FLUSH MOUNT (Monogram only)
22-5/8
36-3/4
Min.
11
23-1/2
K*
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
*See table for desired reveals on sides.
Dimension 1/8"
Reveal
K 30"
1/4"
Reveal
30-1/4"