AT&T CL80115 User Manual page 15

Registration and deregistration
Adding and registering handsets
Register a handset to your telephone base for AT&T models
CL84115/CL84215/CL84265/CL84365
1. Before you begin registration, put the handset near the telephone
base. Make sure the handset is out of the charger and shows
To register HS, see manual.
2. On the telephone base, press mEnU/
3. On the telephone base, press q
Settings, then press
4. Press q
CID
/SELECT.
mEnU
5. Press # (pound key) on the handset. Both the handset and the
telephone base show Registering... Please wait and the In USE
light turns on.
6. After a while, both the handset and the telephone base beep
and the In USE light turns off. The handset displays HAnDSET
X Registered (X represents the registered handset number).
The handset is now registered with the telephone base.
If the registration fails, the system will automatically try to register
again. If registration fails after the third try, Registration Failed
appears on both screens before returning to idle mode. This may
take up to five minutes to occur. Please start again from Step 1.
NOTES:
• You cannot register a handset if any other system handset is in use.
• If you try to register more than 12 handsets to the telephone base, the telephone
base shows Registration slots are full and sounds two beeps.
mEnU
to scroll to Registration, then press
or p
DIR
SELECT
or p
CID
/SELECT.
11
in idle mode.
to scroll to
DIR