Subaru 2009 Forester Owner's Manual page 180

! Skip channel selection
When in the SAT mode, press the "SEEK"
button " " or " " continuously to
change to the channel selection mode.
Pressing the "SEEK" button "
the channel up by 10 steps each time.
Pressing " " changes the channel down
by 10 steps each time.
! Category selection
When in the SAT mode, press the "CAT"
button " " or "
category search mode.
" changes
When in the category search mode,
pressing the "CAT" button "
the category up by one step. Pressing "
changes the category down by one step.
When a category is selected, turning the
"CH" dial selects channels only within the
selected category.
The control function returns to the normal
mode after approximately 10 seconds.
! Channel scan
Press the "SCAN" button to change the
" to change to the
radio to the SCAN mode. In this mode,
under the selected category, the radio
scans through the channel until a station
" changes
is found. The radio will stop at the station
"
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned
from the low end to the high end.
Press the "SCAN" button again to cancel
the SCAN mode and to stop on any
displayed channel.
5-15
Audio
– CONTINUED –