Assembly And Operation; Maintenance - ETC 989991 User Manual

safe place!
Always check that the power supply corresponds to the voltage on the rating
plate.
The machine is double insulated; therefore no earth wire is required.
replacing cables or plugs
If the mains cable becomes damaged, it must be replaced with a special mains cable
available from the manufacturer or the manufacturer's customer service. Dispose of
old cables or plugs immediately after replacing them with new ones. It is dangerous to
connect the plug of a loose cable to a socket.

3. asseMBlY anD OPeraTiOn

Operating the machine
Switching on:
• Push the switch forward to position (1)
Switching off:
• Push the switch back to position (0).
Mounting accessories
For saw blades, scrapers and disc cutters and cutting discs use the clamping screw in
combination with the retaining ring.
• Remove the clamping screw using an Allen key.
• Replace the tool and tighten it using the clamping screw. Check that the tool is
secure in the chuck and that the machine is correctly secured and supported.
Fitting/replacing sandpaper
Using velcro system.
• Place the sandpaper in the middle of the sanding disc and press it firmly with your
hand.
• Press the sandpaper firmly onto the plate with brief, firm pressure and then switch on
the machine. This ensures that the disc is correctly secured and prevents excessive
wear.
• If the sandpaper is worn in a particular spot, you can remove it, turn it 120° and refit
it or replace it.

4. MainTenanCe

The machines have been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper machine care
and regular cleaning.
ETC
GB
49