ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS32SC-CS01
2
TGS32SC-CS02
3
62TGS32SCY101
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #6)
- Hex. Key Wrench (See Part #7)
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic holders
on the underside of the table top (#1) rim. Fasten
them together by using screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
TGS32SC
PART
Q'TY
1
TABLE TOP
4
LEG
1
CENTER CONNECTOR
SERVICE CENTER TOLL FREE NO
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DON'T RETURN TO STORE!
STOP
PAGE 1 OF 2
4
17C17A0403001YX
5
17C40A0705001YX
6
17KAA0101----Y4
7
17KAC3101----Y3
FIGURE 1
2
2
1
COURTYARD CREATIONS INC.
4
SCREW ST4.2*12
4
BOLT M6*15
1
HEX.KEY WRENCH 4MM
1
HEX.KEY WRENCH 10MM
2
2
4
Need help?
Do you have a question about the TGS32SC and is the answer not in the manual?
Questions and answers