Eartec UltraLITE Printable Instructions

Programming

Hide thumbs Also See for UltraLITE:

Programming UltraLITE – Printable

Instructions

Clearing the "Main" Headset

When programming a repaired or replaced unit, the "Main" headset

needs to be Cleared before a "Remote" UltraLite or UltraPAK can be

paired. Follow the steps below to clear the "Main". All Remote headsets

should be "OFF" before starting this process.

1. Install battery in "Main" headset and turn power switch "ON".

2. Press and hold programming button (Blue LED) on "Main" headset

for ﬁve seconds. The LED will begin ﬂashing blue/red.

3. Press the programming button (Blue LED) 7 times. The LED will

begin to blink blue. The "Main" headset is now cleared and is ready to

be paired to a Remote headset or UltraPak belt pack.

-Start at step 2 of "Ultralite / UltraPak Programming Instructions"

below

1. Install battery in "Main" headset and turn power switch "ON". The

blue LED will ﬂash blue.

2. Install battery in "Remote" UltraLite / UltraPak.

3. Press and hold programming button (Blue LED) on "Main" headset

for ﬁve seconds. LED will begin ﬂashing blue/red. This indicates that the

"Main" is ready to link to a "Remote" UltraLite / UltraPak.

Table of Contents

Need help?

Do you have a question about the UltraLITE and is the answer not in the manual?

Page 1 2. Install battery in “Remote” UltraLite / UltraPak. 3. Press and hold programming button (Blue LED) on “Main” headset for ﬁve seconds. LED will begin ﬂashing blue/red. This indicates that the “Main” is ready to link to a “Remote” UltraLite / UltraPak.
Page 2 LED on the remote ﬂashes’ red/blue, release the volume UP arrow. 5. The pairing process can take from 5-30 seconds. When the “Main” unit links to the “Remote” UltraLite / UltraPak the LED will ﬂash twice quickly, then turn solid blue. The “Main” headset will go from a ﬂashing LED to a solid LED.