Advertisement
Bush hog
®
2246QT Quick attach Front-Push Loaders
Pin-on attachment system
Bush hog
Tough FeaTures
®
Tough Boxed Boom Design
Tough Large Diameter Cross Tubes
Tough robotic Welds
Tough high strength Chrome Plated
Cylinder rods
Tough Bush hog Made Buckets
Tough Powder Coat Paint
MoDeL
Specifications Based on 1997 ASAE STANDARDS
Tractor PTo hP range
2WD/FWa
Maximum Lift height - Measured at Pivot Pin
Maximum Lift height - Under Level Bucket
Maximum Dump angle
Digging Depth
Lift Capacity to Maximum Height - At Pivot Pin
Lift Capacity to Maximum Height - 19.5 inches Forward of Pivot Pin
Lift Capacity to 59 inch Height - At Pivot Pin
Lift Capacity to 59 inch Height - 19.5 inches Forward of Pivot Pin
Breakout Force - At Pivot Pin
Breakout Force - 19.5 inches - Forward of Pivot Pin
rollback Force at Maximum Height - 19.5 inches Forward of Pivot Pin
rollback Force at 59 inch Height - 19.5 inches Forward of Pivot Pin
rollback Force at Ground Level - 19.5 inches Forward of Pivot Pin
raising Time (Ground Level to Full Height)
Lowering Time (Full Height to Ground Level)
Bucket Dumping Time (Full Rollback to Full Dump)
Bucket rollback Time (Full Dump to Full Rollback)
hydraulics
Two 1.77 inch Bore, 19.25 inch Stroke Double Acting Bucket Cylinders and Two 1.77 inch Bore, 19.25 inch Stroke Double Acting Lift Cylinders
specifications Based on Tractor system of
Pin-on Buckets
options
Warranty
FeaTures
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Tough
Forklift Attachment (36 inch tines), Bucket Level Indicator, and Grill Guards
2246QT
15 - 35
2WD/FWA
97 inches
90 inches
50°
4 inches
1150 lbs
875 lbs
1365 lbs
1085 lbs
1995 lbs
1525 lbs
2040 lbs
2410 lbs
1820 lbs
4 seconds
2 seconds
4 seconds
2 seconds
2000 PSI hyd. Pressure & 6 GPM pump capacity
Available in 48, 60 and 72 inch widths
1 year limited warranty
Available in major tractor colors
Page 73
Advertisement
Table of Contents
Need help?
Do you have a question about the Front-Push Loaders 2246QT and is the answer not in the manual?
Questions and answers
How to make hydraulic connection on a 1910 ford tractor
To make a hydraulic connection for a Bush Hog Front-Push Loader 2246QT on a 1910 Ford tractor:
1. Remove the plug from the right side of the control valve.
2. Install the power beyond plug into the valve.
3. Install a 90˚ elbow into the power beyond plug.
4. Attach a hydraulic hose to the 90˚ elbow.
5. Route the hose to the return outlet on the tractor.
6. Use additional fittings as required to connect the hose to the tractor’s return outlet.
7. Ensure the tractor hydraulic circuit is completed by connecting the pressure port to the return port when loader is disconnected, to prevent damage to the tractor hydraulic pump.
Relieve all hydraulic pressure before disconnecting any hydraulic lines.
This answer is automatically generated