Saab 2006 9-5 Owner's Manual page 241

Jacking points for a trolley jack
Tighten the bolts enough for the bolts
and wheel to be seated correctly.
7 Lower the car and tighten the wheel
bolts to the correct torque in the
sequence shown (opposite pairs).
Tightening torque
Light-alloy wheels: 80 ft.lbs. (110 Nm)
Steel wheels: 80 ft.lbs. (110 Nm).
Clean any rust or dirt from the contact sur-
faces between the wheel and brake disc
NOTICE
• When refitting wheel covers (where
applicable), make sure that the valve
protrudes through the marked hole in
the wheel cover.
• Do not overtighten the bolts using an
impact wrench: not only can this
damage the wheels but it can also
make it impossible to undo the bolts
using the wheel wrench in the car's
toolkit.
Car care and technical information
Do not wipe away the grease in the hub.
8 Check-tighten the wheel bolts after a few
miles.
Tightening torque
Light-alloy wheels: 80 ft.lbs. (110 Nm)
Steel wheels: 80 ft.lbs. (110 Nm)
241