Saab 2005 9-7X Owner's Manual page 294

8. Now connect the black negative ( ) cable to the
negative ( ) terminal of the good battery. Use a
remote negative ( ) terminal if the vehicle has one.
Do not let the other end touch anything until the
next step. The other end of the negative ( ) cable
does not go to the dead battery. It goes to a
heavy, unpainted metal engine part or to the remote
negative ( ) terminal on the vehicle with the dead
battery. Your vehicle has a remote negative ( )
terminal, marked GND, for this purpose.
4.2L L6 Engine
The remote negative ( ) terminal is located on the
front engine lift bracket for the 4.2L L6 engine, and on
the accessory drive bracket for the 5.3L V8 engine.
5-42
9. Connect the other end of the negative ( ) cable to
10. Now start the vehicle with the good battery and run
11. Try to start the vehicle that had the dead battery.
Notice: If the jumper cables are connected or
removed in the wrong order, electrical shorting may
occur and damage the vehicle. The repairs would
not be covered by your warranty. Always connect
and remove the jumper cables in the correct
order, making sure that the cables do not touch
each other or other metal.
5.3L V8 Engine
the remote negative ( ) terminal on the vehicle with
the dead battery.
the engine for a while.
If it will not start after a few tries, it probably needs
service.
2005 - Saab 97X Owner Manual