Saab 2001 9-3 Owner's Manual page 22

22 Safety
LATCH installation
To facilitate the proper fitting of new spe-
cially-design child restraints, 9-3's except
Convertibles have rigid lower anchorages
(ISOFIX) and top tether anchorages in the
two outboard rear seating positions. There
is an additional top tether anchorage for the
center rear seating position.
LATCH is a U.S./Canadian government
standard for an uniform method of fitting
child restraints without using the standard
safety belts. Only certain child restraints are
equipped to utilize these rigid lower anchor-
ages behind where the seat cushion and
seat back come together. LATCH child
seats also utilize a top tether strap that is
found on some newer child seats that still
require installation with the standard safety
belts.
There are two bars attached to the car body
for each specially designed LATCH child
restraint. A small circular label is located on
the seat back just above each attachment
bar to facilitate installing the child restraint.
1 Place the child restraint on one of the
designated outboard rear seat cushions.
2 Press the child restraint rearward, lining
up the restraint attachment arms with
the labels.
3 Follow the child restraint instructions to
confirm that both restraint arms are
properly attached to the bars.
4 Attach the top tether strap to the in-car
anchorage and tighten according to the
restraint instructions, see page 23 and
24.
5 Pull the child restraint to make a second
check that restraint is securely attached
at both the lower anchorage bars and
the top tether strap.
For the top tether, only use the strap sup-
plied with the child restraint.
Always follow the installation instructions
supplied with the child restraint.
The availability of LATCH child restraints
may be limited.
Child restraints using rigid lower anchor-
ages (ISOFIX) cannot be fitted where a inte-
grated booster seat is installed.
Rigid 2-point lower attachment with top
tether
Semi-rigid 2-point lower attachment with
top tether