Summary of Contents for Campania International Austin FT-206
Page 1
FT-206 Austin Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 17 gallons of water. • This fountain uses a medium fountain cover: FTNCOV-MED • Compatible with #10 Refi ll Device and LED kits • A special stopper is required to use the refi ll kit for this fountain Pump Information: OEMPF525 - 525 GPH Pump (16 ft.
Page 2
FT-206 Austin Fountain Assembly Instructions Two people are recommended for the installation of this fountain! Fountain Set-Up: Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin.
Page 3
FT-206 Austin Fountain Assembly Instructions UNDER THE BOWL (FT-206A) Step 7 - Position the bowl (FT-206A) over the large pedestal (FT-206B). Step 8 - Insert the CPVC end of the tubing assembly into the pipe protruding from the bottom of the bowl (FT-206A).
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.