NEC MultiSync InGlass Touch V Series User Manual page 12

Connections
Monitor Setting
Select the input signal.
 Using slot 2 type PC: Select [OPTION]
 Using external computer: Select the input signal which is supplied by the computer connected to
USB connector.
NOTE: Please refer to "The touch panel does not respond" in "Troubleshooting" when the touch panel
function does not work.
Enable the USB Hub
HUB
7
Use the short 10 cm USB cable supplied with the monitor. Connect
USB cable from USB Type-B input marked with "Hub" (located
above external speaker terminals) to USB Type-A input marked
with "USB 1" on the side of the monitor. The red LED on the USB
hub will light up.
NOTE: To enable USB 3.0 on USB ports on the USB hub you
need to connect the 3 m USB cable supplied with the monitor to
one of the USB 3.0 ports of the OPS slot-in PC.
NOTE: When connected to an external PC, use the 3 m USB
cable supplied with the monitor. Connect USB cable from USB
USB 1
Type-B input marked with "Hub" to USB Type-A input of the
TOUCH
external PC.