Control Panel Layout; Normal Operating Sounds - Soleus Air WM1-12E2-01 Operating Instructions Manual

CONTROL PANEL LAYOUT

Electronic Control Panel & Remote
Control
Note: This control panel display always shows the
room temperature in Fan Mode except when setting
the temperature and timer.

Normal Operating Sounds


You may hear a pinging noise caused by
water hitting the condenser on rainy days, or
when the humidity is high. This design
feature helps remove moisture and improve
efficiency.

You may hear the thermostat click when
the compressor cycles on and off.

Water will collect in the base pan during
rain or days of high humidity. The water
may overflow and drip from the outside part
of the unit.

The fan may run even when the
compressor is not on.
1. Power Button: Turn the air conditioner on
and off.
2. Digital Display: Will display set temperature
when the unit is in Cool, Dry, Auto, Sleep,
Energy Saver mode, and display current room
temperature when in Fan mode.
3. Temperature Set: Use these buttons on the
control panel or remote to increase or
decrease the Set Temperature.
4. Timer Set: Use these buttons on the
control panel and remote control to set
the timer. Each press of the▲or▼ button
will increase or decrease the timer. For
timer instructions see #7.
5. Fan Speed: Use the fan speed button to
change the fan speed. Choose between
high, medium, and low.
6. Mode Button: Press the MODE button to
cycle through the various modes: Auto,
Sleep, Energy
7. Auto-on Timer: When the air conditioner is
off, it can be set to automatically turn on in 1-
24 hours at the previous set mode and fan
settings. To set the Auto-on Timer, press the
DELAY TIMER button on the unit or remote
control. Timer can be set in 1 hour increment.
Auto-off Timer: When the air conditioner is on, it
can be set to automatically turn off in 1-24 hours.
To set the Auto-off Timer, press the DELAY
TIMER button on the unit or remote control.
Timer can be set in 1 hour increment.
Once timer is set, TIMER ON/OFF indicator on
control panel will light up, the set temperature will
also, shown on digital display.

To see the remaining time, press DELAY TIMER
button. To change the timer settings, use the
▲or▼ on control panel or remote control.

During preview of timer setting, press DELAY
TIMER button once to display set time, press the
button one more time to cancel the settings.
8. Filter Reset: After the fan rotates for 250
total hours, the filter check light will turn on
to remind the user to clean the filter. Press
the FILTER RESET button to reset the
reminder once the filter is cleaned.
9. Signal Receiver: Point the remote control
to the air conditioner when sending
instruction to the unit.