Philips HD8821 User Manual page 52

ENGLISH
50
Machine actions
The machine grinds the
coff ee beans but no coff ee is
brewed (see note).
The coff ee is too weak (see
note).
Coff ee is brewed slowly (see
note).
Coff ee leaks out of the coff ee
dispensing spout.
No hot water or steam is
dispensed.
The descaling cycle cannot
be fi nished.
Causes
The brew group is dirty.
The circuit is not primed.
This might occur when the ma-
chine is automatically adjusting
the dose.
The coff ee dispensing spout is
dirty.
This might occur when the ma-
chine is automatically adjusting
the dose.
The ceramic coff ee grinder is set
to a coarse grind.
The coff ee grind is too fi ne.
The circuit is not primed.
The brew group is dirty.
The coff ee dispensing spout is
clogged.
The hole of the steam/hot water
wand is clogged.
You have used not enough water
for rinsing.
Note:
These problems can be considered normal if the coff ee blend has been
changed or if the machine has just been installed. In this case, wait until
the machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.
Solutions
Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
Prime the circuit (see the "Using the
Machine for the First Time" chapter).
Brew a few cups of coff ee as
described in the "Saeco Adapting
System" chapter.
Clean the coff ee dispensing spout.
Brew a few cups of coff ee as
described in the "Saeco Adapting
System" chapter.
Adjust the ceramic coff ee grinder
to a fi ner setting (see the "Adjust-
ing the Ceramic Coff ee Grinder"
chapter).
Change coff ee blend or adjust the
grind as explained in the "Adjusting
the Ceramic Coff ee Grinder" chapter.
Prime the circuit (see the "Using the
Machine for the First Time" chapter).
Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
Clean the coff ee dispensing spout
and its holes.
Clean the hole of the steam wand
using a pin.
Make sure that the machine is
off and has cooled down before
performing this operation.
Press the ON/OFF button and follow
the instructions described in the
"Interruption of the Descaling Cycle"
chapter.