LevelOne FCS-4102 User Manual page 36

Network Camera User's Manual
General Setting
1. "Color mode"
Select use color or monochrome video display.
2. "Video orientation"
(1) "Flip"
Vertically rotate the video.
(2) "Mirror"
Horizontally rotates the video.
3. "Environment"
The orientation of video
(1) "indoor"
This option is usually selected when the Network Camera is placed
in indoor environments.
(2) "outdoor"
This option is usually selected when the Network Camera is placed
in outdoor environments.
4. "Power freq."
Select 50 Hz or 60Hz power line frequency.
※ The fluorescent light will flash according to the power line frequency that
depends on local utility. Change the frequency setting to eliminate uncomfortable
flash image when the light source is only fluorescent light.
Video Setting
1. "Contrast"
Adjust the image contrast level, which ranges from -5 to +5. The default
value is set to 0.
2. "Brightness"
Adjust the image brightness level, which ranges from -5 to +5. The
default value is set to 0.
3. "Saturation"
Adjust the image saturation level, which ranges from -5 to +5. The
default value is set to 0.
4. "Sharpness"
Adjust the image sharpness level, which ranges from -5 to +5. The
default value is set to 0.
"EV" Exposure value represent the expected target value of the luminance of
5.
the weighting result of AE windows in the image and its tolerance as offset.
"Gain" In the slide bar of Gain, there are also two sliders, which represent the
6.
limitations to control the maximum gain value and the minimum one, respectively.
Normally, the minimum value is to 1x for better quality.
The orientation of video
36/61