Mitsubishi Electric MR-WX743C Operating Instructions Manual page 29

When attaching parts, use the backward procedures of removal.
Glass Shelf (Upper) (Middle) (Lower)
Pull out to the front using both hands
1
until making contact with the tabs.
Lift the front of the shelf to remove the tabs.
Pull out until making
contact
Tab
Hold the front and back of the glass
2
shelf (lower) and pull the back out to
the front of the rail. Lift the front to
make the glass shelf upright.
Backside (in the upright
position)
3 Pull out the right side or left side of
the glass shelf (lower) (in the upright
position of ) to remove from the
2
refrigerator.
* Remove with the partition attached after
you have removed the glass shelves
(upper) and (middle) and slide glass shelf.
Partition
1 Remove the glass shelf (lower) and place it on a
surface such as a stand.
2 Press the glass shelf (lower) down with one hand.
* The shelves are firmly installed.
3 Pull in the direction indicated by the arrow.
Be careful when attaching and
removing the glass shelf.
If it is attached improperly, it could come
Follow the loose and fall, causing injury.
instructions
1
Rail
2
3
2
3
Adjustable Pocket (Large) (Small) /
Bottle Pocket (Large) (Small)
1 Lift up the left and right of the pocket alternately.
* The pockets are firmly installed.
2 Pull out to the front.
2
1
Adjustable Pocket
Be careful when attaching and
removing the pocket.
If it is attached improperly, it could come
loose and fall, causing injury.
Follow the
instructions
Slide Glass Shelf (Front) (Back)
1 Remove the slide glass shelf (front) using the protruding
parts in the front and back along with the grooved parts.
Protruding
Part
Grooved
Part
2 Pull the slide glass shelf (back) out to the front
while holding the front with both hands.
* Swiftly pulling out the part to the front can damage the
side of the door. Pull out the part slowly to remove it.
Lower Case
1 Fully pull out the lower case.
2 Lift the lower case out to the front.
2
1
Bottle Pocket
1
2
2
1
Cleaning
29