Intec i-Starter 3.5 Manual page 12

English
Emergency start
1. The device must be properly charged, with the four blue LEDs of the indicator
switched on.
2. Connect the red clamp to the positive terminal (+) of the battery, or to the
remote positive pole. Connect the black clamp to the negative pole (-) of the
battery or to the remote negative pole.
3. The connection must be realized with both sides of the clam firmly attached
to the metal. In case of sulphur deposits on the pole, these must be previously
removed.
Beep, Beep
Beep, Beep
4. Turn the ignition key for a maximum of 3 seconds and then wait for a further
3 minutes before attempting to jump start again.
5. When the engine is running, remove one clamp at a time, return the clamps
to their housing and recharge the starter as soon as possible.
Note: when the push button is pressed for over two seconds, the security function
of the device is inhibited for 30 seconds. Once the engine has been jump started,
the cables must be quickly disconnected from the battery in order not to overload it.
12
GREEN LIGHT on:
Telling the connection
is correct and the
circuit is working, you
Beep, Beep
Beep, Beep
can turn on the engine
to jump-start directly.
GREEN LIGHT blinking
with buzzing:
Indicates very low
Beep, Beep
battery. Press the push
Beep, Beep
button for two seconds
and then jump start the
engine.
RED LIGHT on with
buzzing:
Indicates reversed
polarity. Invert the
Beep, Beep
Beep, Beep
connection immediately.
No Lights on, No
buzzing:
Indicates absent or
interrupted vehicle battery.
Press the push button for
two seconds and then
jump start the engine.