Panasonic WH-SDC12H9E8 Service Manual page 21

11.1.6.4 Mounting The Remote
Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Cut here with
a nipper and
remove the burr
with a file.
Claw (2 places)
Screw
(field supply)
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
Bottom case
(Back side)
For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
Screw
(field supply)
Connect the remote
control wiring
Bottom case
(Back side)
Mount the bottom case to
the wall.
U P
Wall to which
the remote
controller is
fixed
Hole for screw
Claw (2 places)
Clamper
(field supply)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Top case
(Back side)
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
U P
Hole for
screw
Claw (2 places)
Remote controller
terminal board
Remove the coating.
Top case
Approx. 6 mm
(Back side)
Make sure the wiring
connection is in the correct
direction.
11.1.6.5 Replace The Remote Controller
Cover

Replace the existing Remote controller cover with
Remote controller cover
after remove the Remote controller.
1. Release the Remote controller cover's hooks from
behind the front plate.
Existing Remote
controller cover
2. Press from front to fix the Remote controller cover
6
on the front plate.
Remote
controller
cover 6
11.1.7 Charging The Water

Make sure all the piping installations are properly
done before carry out below steps.
1. Turn the plug on the Air Purge Valve
anticlockwise by one complete turn from fully
closed position.
Air purge valve
63
6
to close the hole left
Front plate
Hook (6 places)
Front plate
Hook (6 places)
9
outlet
Plug (turn
anticlockwise by
one complete turn)
9