Table of Contents
Advertisement
Setting and Service
L20 / M35-Trail and M45-Trail - PTO Tractor
●
A standard PTO shaft can maximum resist an angle turning of 25º
●
A wide angle PTO shaft can maximum resist an angle turning of 80º
If there is a need for turning angles higher than 25º - The carriage must be fitted with a wide angle PTO shaft.
L20 / M35-Trail and M45-Trail - adjustment of wheel hub
Servicing and adjusting the clearance in the taper roller bearings on the wheel hub. It is important to check and
adjust the clearance every 50 hours of use.
After every 50 hours:
●
Position the Trailer on a level and stable surface and lift the wheel clear of the ground - free to rotate.
●
Place a lever between the tyre and the ground and by lifting and lowering the lever, verifying that that there is no
clearance in the hub.
In case of clearance adjust the lock nut as follows
●
Dismantle the hubcap (1).
●
Remove the split pin (2) from the lock nut (3).
●
Tighten the lock nut until the clearance is equalised (3).
●
Check that the wheel is free running without resistance. A slight clearance is preferred - opposite bearing
resistance.
●
Fit a NEW split pin (2) greese and assemble the hub.
Figure 1
(see figure 1)
The wheel hub must be greased every 50 hours.
Grease nipple (4)
:
11
Advertisement
Table of Contents
