Table of Contents
Advertisement
10.8.1. DISASSEMBLING THE OPTICAL PICKUP UNIT
1. Remove the two screws and remove the TRV feed rack.
2. Remove the FFC cable.
3. Remove the optical pickup.
10.8.2. CAUTIONS TO BE TAKEN WHEN REPLACING THE OPTICAL PICKUP
- Replace the optical pickup according to the following procedure.
1. Install the TRV feed rack on the optical pickup (see
2. Install the Optical Pickup Unit, Spring, Drive shaft, Guide shaft
and Spring holder on the Traverse block.
Cautions to be taken when assembling the unit: Install the Pickup
Unit so that it is located at the rear end of the Guide shaft.
3. Install the FFCable (see
PDF created with pdfFactory Pro trial version
Fig. 1
Fig.
1).
Fig. 2
46
www.pdffactory.com
Fig.
1).
Advertisement
Table of Contents
