Advertisement
The JA-152P / JA-152P (G) Wireless PIR motion detector
Detection characteristics
The detector is fitted with a lens (2) covering an area of 90°/12 m with
3 beams (curtains) – see figure 3. The lens cannot be replaced
by a different type of lens. This detection characteristic is the same for
both the white and the grey lens.
Figure 3. This detection characteristic is valid for standard PIR immunity.
Installation accessories
JA-196PL-B-S – Detector wall holder
When an aesthetic installation is required, it's possible to install
the detector on a wall surface using a JA-196PL-B-S aesthetic frame
and mounting box, which is distributed in two colours – white and grey.
Using the frame, the detector is partially hidden under a plaster
or plasterboard wall.
JA-191PL – PIR jointed bracket
It is used for special placement, such as installation on the ceiling
or at a tilted angle (higher installation height). The jointed bracket
is a certified detector accessory having its own tamper contact which
is to be connected to the connector inside the detector (7).
The JA-152P / JA-152P (G) Wireless PIR motion detector
Technical specifications
Power
1 Lithium battery type CR123A (3 V/1500 mAh)
Typical battery lifetime
Low battery voltage
Current consumption in standby mode
Maximum current consumption
Communication band
Communication range
Recommended installation height
Detection angle / detection coverage
Dimensions
Weight (without battery)
Classification
Operational environment
Operational temperature range
Average operational humidity
Certification body
Complies with
ETSI EN 300 220-1,-2, EN 50130-4 ed. 2+A1,
Can be operated according to ERC REC 70-30
JABLOTRON ALARMS a.s. hereby declares than the JA-152P
(G) is in a compliance with the relevant European Union
harmonisation
2014/35/EU, 2014/30/EU, 2011/65/EU, when used as intended.
The original of the conformity assessment can be found
at
www.jablotron.com
Note: Although this product does not contain any harmful
materials we suggest you return this product to the dealer
or directly to the producer after use.
2 / 2
Please note: Battery not included
(the longest in smartwatch mode, at 20°C)
868.1 MHz, JABLOTRON protocol
approx. 300 m (open area)
2.2 – 2.5 m above the floor
62 x 110 x 40 mm
Security grade 2/Environmental class II
(according to EN 50131-1)
Indoor general
-10 °C to +40 °C
75 % RH, non-condensing
Trezor Test s.r.o. (no. 3025)
EN 50131-1 ed. 2+A1+A2, EN 50131-2-2,
EN 50131-5-3+A1, EN 50131-6 ed. 2+A1,
EN 55032, EN 62368-1, EN 50581
legislation:
Directives
No:
2014/53/EU,
–Downloads section.
MMO57101
4 years
< 2.4 V
30 μA
100 mA
90°/12 m
90 g
Advertisement
