Configuring The Revo C/Revex Communication Port Settings - Cascade REVO C Engineering Manual

2. CONFIGURING THE REVO C/REVEX
COMMUNICATION PORT SETTINGS
To configure the REVO C/REVEX communication port (i.e. set to correct Modbus
address 1, 2, 3 or 4 and 19200bps N81) you must make use of the thyristor configurator
tool that you can download from the CD automation website.
https://www.cdautomation.com/product/software/#gref
Here you can also download the drivers for the USB interface
For the service touchscreen, you need to adjust the Modbus slave port on each REVO
C/REVEX to a Modbus address 1, 2, 3 or 4 and 19200bps N81.
First connect the 24VDC power supply to the Revo C or REVEX unit (see manual) and
make sure you have connection with it via a micro-usb cable (maybe your mobile phone
has it).
First check in windows on which comport the interface to the Revo C/REVEX has been
mapped. Keep on using always the same USB port because windows mappes other
COMport number to each different USB port (don't know why?).
Start the thyristor configuration tool and adjust the comport settings to what you found in
the device settings. Do this with setting-communication
REVO C/REVEX Service Panel Engineering Manual V1.0 Page 12