Connect The Cable To The Outdoor Unit - Panasonic WH-SXC12H6E5 Service Manual

Connect The Cable To The Outdoor Unit

(FOR DETAIL REFER TO WIRING DIAGRAM AT UNIT)
1. Remove the control board cover from the unit by loosening the screw.
2. Connecting cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed flexible
cable (see below table), type designation 60245 IEC 57 or heavier cable.
3. Secure the cable onto the control board with the holder (clamper).
4. Attach the control board cover back to the original position with screw.
Models
UX09*E5*, UX12*E5*,
UD12*E5*, UD16*E5*
Terminals on the indoor unit
Colour of wires
Terminals on the outdoor unit
•
Select required direction and apply protective bushing provided in accessories to protect cables from sharp edges.
•
Once all wiring work has been completed, tie the cable and cord together with the binding strap so that they do not touch other parts such as the
compressor and bare copper pipes.
Outdoor Unit
This equipment must be properly earthed.
Flexible cable specification
2 2
4 × min 4.0 mm or 6.0 mm
1 2 3
1 2 3
Earth Wire
must be
longer than
others cables
for safety
reason.
Indoor/outdoor unit
terminal board
Cord clamp
Banding strap
(Field Supply)
Connecting cable
(refer below
diagram for its
guiding)
WARNING
Models
UX09*E8*, UX12*E8*,
UX16*E8*, UD09*E8*,
UD12*E8*, UD16*E8*
Terminals on the indoor unit
Colour of wires
Terminals on the outdoor unit

For three phase model never operate the unit by pressing the
electromagnetic switch.

Never correct the phase by switching over any of the wires
inside the unit.
Protective
bushing
Apply cut
DETAIL OF CONNECTING CABLE GUIDING
Flexible cable specification
2
6 × min 1.5 mm
1 2 3 4 5
1 2 3 4 5
Earth Wire
must be
longer than
others cables
for safety
reason.
CAUTION
3
Selection
of direction