Page 2
DDMEXT3 ‐ Product update 1.) Take off the cover ‐ by removing 8 M4X10 screws BE CAREFUL NOT TO DAMAGE THE COVER Then remove the 2 M4X6 screws that hold the motor, as shown in the picture. ONLY REMOVE THE SCREWS SHOWN You can discard the 2 screws that have been removed...
Page 3
DDMEXT3 ‐ Product update 3.) Place the supplied plate as shown in the figure, the two smaller holes of the plate have to correspond with the holes of the screws removed in step 2. 4.) Using the supplied M4X10 screws and the washers fix the plate onto the body, as shown in figure 4...
Page 4
DDMEXT3 ‐ Product update 5.) Using a 2.5mm drill bit make 5 holes on the body as shown in figure 5 6.) By using the supplied self tapping screws securely fix the plate to the appliance...
Page 5
DDMEXT3 ‐ Product update 7.) Reassemble the appliance by attaching the cover to the body using the screws removed in step ...
Page 6
New product information sheet Product name: Motor 3 Description: Extraction motor Product code: DDMEXT3 Features Motor for use with all Caple downdraft hoods and Ceiling hoods For installation on outside wall 7m long connection cable Aluminium die-cast construction Performance Max. extraction 1000m3/h...
Page 15
75097200003 SEM8 WIRING BOARD (From Feb-11) 44001299998 MOTOR GROUP EBM R2E250 75070999999 ACCESSORIES BAG SEM 2 77007399999 INSTRUCTION MANUAL DDMEXT2 DDMEXT3 DDMEXT4 90004200372 42429999999 CABLE WITH CONNECTION MT.7 SEM2 (To Feb-11) 42439999999 7mt CABLE FOR SEM2 ECO-AO75 (From Feb-11) 42041999999...