Mercury 2009 Mountaineer Owner's Manual page 135

TRAILER SWAY REDUCE SPEED — Displayed when your trailer
starts to sway when towing. Refer to Trailer sway control in the
Driving chapter for more information.
FOR 4X4 LOW STOP VEHICLE (if equipped) — Displayed when
4X4 LOW is selected while the vehicle is moving. For more information,
refer to Using the Control Trac 4WD system in the Driving chapter.
FOR 4X4 LOW SHIFT TO N (if equipped) — Displayed when 4X4
LOW is selected and the vehicle is stopped. For more information, refer
to Using the Control Trac 4WD system in the Driving chapter.
TO EXIT 4X4 LOW STOP VEHICLE (if equipped) — Displayed
when 2WD is selected while the vehicle is operating in 4X4 LOW. For
more information, refer to Using the Control Trac 4WD system in the
Driving chapter.
TO EXIT 4X4 LOW SHIFT TO N (if equipped) — Displayed when
2WD is selected while the vehicle has been stopped in 4X4 LOW. For
more information, refer to Using the Control Trac 4WD system in the
Driving chapter.
POSITIVE RETENTION FLOOR MAT
WARNING: Do not install additional floor mats on top of the
factory installed floor mats as they may interfere with the
accelerator or the brake pedals.
Position the driver floor mat so that
the eyelet is over the pointed end of
the retention post and rotate
forward to lock in. Make sure that
the mat does not interfere with the
operation of the accelerator or the
brake pedal. To remove the floor
mat, reverse the installation
procedure.
2009 Mountaineer (mnt)
Owners Guide, 2nd Printing
USA (fus)
Driver Controls
135