J39L(02MY).book Page 23 Thursday, November 1, 2001 10:49 AM
3. Tighten the bolt at both ends of the rear
cross bar alternately and evenly.
Bolt
NOTE
• If only one bolt is tightened, the
cross bar will lean to one side.
• Tighten the bolts with tightening
torque of 11—12 N•m {110—120
kgf•cm}.
4. Install the rear cross bar cover by
inserting the clips into the square hole
of the rear cross bar until they click,
then tighten the screw.
Rear cross bar
cover
Form No. 8Q36-EA-01F
Screw
Rear cross bar
Knowing Your Mazda
Doors and Locks
3-23