Mazda 2002 Protege Owner's Manual page 78

J39L(02MY).book Page 22 Thursday, November 1, 2001 10:49 AM
Knowing Your Mazda
Doors and Locks
CAUTION
• The roof rack is not designed for
direct placement of objects or loads.
A special attachment kit is
necessary. Consult an Authorized
Mazda Dealer.
• The maximum load on the roof rack
is 75 kg (165 lb). Do not overload.
• Because the bolts and screws may
loosen initially, retighten them.
Periodically check bolts for
looseness approximately every 100
km (62 miles).
• Avoid turning sharply and jamming
on the brakes while the roof rack
installed. Doing so may cause an
accident or the luggage may fall off.
• Road conditions (especially steep
curves or rough roads) and weather
changes (strong cross wind, head
wind, rain, snow, or fog) can change
vehicle operating characteristics
greatly when the vehicle is
equipped with the roof rack. To
cope with these conditions, drive at
a slower speed.
• When driving in a tunnel or parking
garage or any place with height
restrictions with the roof rack
installed, be aware that the roof rack
will raise the total clearance of the
vehicle.
• If the vehicle is washed in an
automatic car wash with the roof
rack installed, the roof rack or the
roof of the vehicle can be damaged.
Before washing the vehicle in an
automatic car wash, always remove
the roof rack.
3-22
Form No. 8Q36-EA-01F
M Roof Rack Adjustment
1. Loosen the screw at both ends of the
rear cross bar, then remove the rear
cross bar covers.
Screw
Rear cross bar cover
2. Loosen the bolt at both ends of the rear
cross bar, then slide the rear cross bar
to the desired position.
Bolt
Rear cross bar