Table of Contents
Advertisement
Driver Controls
System check
Selecting this function from the
SETUP menu causes the message
center to cycle through each of the
systems being monitored.
Pressing the RESET control cycles
the message center through each of the systems being monitored.
Note: Some monitored systems show a message only if a warning is
present.
The sequence of the system check report is as follows:
1. OIL LIFE
2. WASHER FLUID LEVEL
3. DOOR AJAR STATUS
4. TRUNK AJAR/CLOSED
5. BRAKE SYSTEM
6. TIRE PRESSURE
7. REMOVE OBJECTS NEAR PASSENGER SEAT
8. ADAPTIVE CRUISE CONTROL (if equipped)
9. PARK AID
10. FUEL LEVEL
Oil life
An oil change is required whenever indicated by the message center.
USE ONLY RECOMMENDED ENGINE OILS.
To reset the oil monitoring system to 100% after each oil change
(approximately 7,500 miles [12,000 km] or six months) perform the
following:
1. Press the SETUP control to enter
SYSTEM CHECK, then press SETUP
control again to display "OIL LIFE =
XXX% HOLD RESET = NEW".
87
Advertisement
Table of Contents
