Driving On Slippery Surfaces; Acceleration - Jeep 2010 Patriot Owner's Manual

Four-Wheel Drive Switch
Where one or more wheels have wheel spin or if addi-
tional traction is needed in sand, deep snow, or loose
traction surfaces, activate the "4WD LOCK" switch by
pulling up once and releasing. This locks the center
coupling allowing more torque to be sent to the rear
wheels. The "4WD Indicator Light" will come on in the
cluster. This can be done on the fly, at any vehicle speed.
To deactivate, simply pull on the switch one more time.
The "4WD Indicator Light" will then go out.
NOTE: Refer to "Electronic Brake Control System/
Electronic Stability Control (ESC)" in "Starting and Op-
erating" for further information.

DRIVING ON SLIPPERY SURFACES

Acceleration

Rapid acceleration on snow covered, wet, or other slip-
pery surfaces may cause the front wheels to pull errati-
cally to the right or left. This phenomenon occurs when
there is a difference in the surface traction under the front
(driving) wheels.
STARTING AND OPERATING 301
5