Table of Contents
Advertisement
Available languages
Available languages
EN
TECHNICAL DATA
Computer
Distance
Time
Odometer
Calories
Pulse
Control unit
Battery
Operating temperature
DESCRIPTION
No.
Description
1
Frame
2
Front foot
3
Back foot
4
End piece for back foot
5
Screw M8 x 70
6
Spring washer
7
Dome nut M8
8
Crank arm
9 L/R
Pedal
10
End piece for front foot
11
Sensor cable
12
Load wire
13
Extension cable
14
Screw M8 x 16
15
Bushing
16
Screw
17
Handlebar post
18
Flat washer
19
Load control
20
Cable to hand pulse sensor
21
Foam rubber grip
22
End piece, handlebars
23
Screw
24
Spring washer
25
Handlebars
26
Computer
27
Washer Ø 8.2 x Ø 20.2
28
Saddle post
29
Knob
30
Cover, handlebar post
31
Cover, saddle post
24
32
33
0.1-999.9 km
34
0:00-99:59 min
35
0.1-999.9 km
0.1-999.9 kcal
40-240 spm
4-bit microprocessor
2 x 1.5 V AAA
0 to 40˚C
1.
2.
Qty
1
3.
4.
1
5.
1
2
6.
4
8
4
2
1.
2
2
2.
1
1
3.
1
4.
6
1
1
The end piece for the back foot can be adjusted in height to
1
ensure that the exercise bike stands firmly on the floor.
1
2
2
2
The crank arms, pedals, pedal axles and pedal straps are
marked with R for right and L for left.
4
1.
10
1
1
Do NOT turn the left pedal clockwise, this will damage the
2
thread.
1
2.
1
1
1
Saddle
Flat washer
Nyloc nut M8
Screw 4.2 x 18 mm
FIG.
1
ASSEMBLY
Battery
Release the battery cover and insert two AAA batteries in the
battery compartment on the back of the computer unit,
see diagram below.
Check the polarity of the batteries and that the battery
springs are in good contact with the batteries.
Replace the battery cover and check that it is secure.
The battery life is approx. 1 year during normal use.
If the display cannot be read, or only partially, remove the
batteries and wait 15 seconds before replacing them.
The exercise bike memory is deleted when the batteries are
taken out.
Front and back foot
Place the front foot (2) in front of the frame (1) and align the
screw holes.
Fasten the front foot on the front bracket on the frame with
2 screws, 2 spring washers and 2 dome nuts.
Place the back foot (3) behind the frame and align the screw
holes.
Fasten the back foot on the back bracket on the frame with
2 screws, 2 spring washers and 2 dome nuts.
FIG.
2
NOTE:
Pedals
NOTE:
Insert the left pedal axle in the threaded hole in the left
crank arm. Screw tight the pedal anticlockwise by hand.
WARNING!
Insert the right pedal axle in the threaded hole in the right
crank arm. Screw tight the pedal clockwise by hand.
FIG.
3
1
3
3
4
Advertisement
Table of Contents
