Hyundai 2006 Santa Fe Owner's Manual page 238

6. Draw a vertical line (through the center of
each headlight beam pattern) and a horizon-
tal line (through the center of each headlight
beam pattern) on the aiming screen.
And then, draw a parallel line at 0.8 in. (21
mm) under the horizontal line.
7. Adjust each cut-off line of the low beam to the
parallel line with a phillips screwdriver -
VERTICAL AIMING.
!
WARNING:
Horizontal aiming should be adjusted by
an authorized Hyundai dealer.
G290B01O-AAT
Adjustment After Headlight Assembly
Replacement
Vertical line
Horizontal line
W
Cut-off line
L
Ground line
H
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using an
aiming chart as shown in the illustration. Turn on
the headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustration.
2. Dotted lines in the illustration show the center
of headlights.
DO-IT-YOURSELF MAINTENANCE
SPECIFICATION:
"H";
Horizontal center line of headlights from
ground: 2WD : 32.5 in.(822 mm)
4WD : 33.3 in.(843 mm)
"W";
"P"
Distance between each headlight center:
46.5 in.(1,178 mm)
H
"L";
Distance between the headlights and the
wall that the lights are tested against:
118 in. (3,000 mm).
G290A03O
6
25