Changing The Climate Control Air Filter - Hyundai 2006 Elantra Owner's Manual

G140D01A-AAT
Checking the Compressor Drive Belt
A/C
0.315 in. (8 mm)
TENSION PULLEY
CRANK PULLEY
When the air conditioning is being used regu-
larly, the compressor drive belt tension should
be checked at least once a month with the
engine turned off.
To check the drive belt tension, press down on
the belt halfway between the engine crankshaft
and compressor pulleys. Pressing with your
finger, you should not be able to deflect this belt
anymore than 1/3 of an inch. If you have the
instruments to check it, with a force of 22 lb.
(98N), the deflection should be 0.315 inches
(approx 8.0 mm). If the belt is too loose, have it
adjusted by your Hyundai dealer.
CHANGING THE CLIMATE CONTROL AIR
FILTER
B140E02E-AAT
(For Evaporator and Blower Unit)
The climate control air filter is located in front of
the evaporator unit behind the glove box.
It helps to decrease pollutants from entering the
car.
G140D01A
1. Open the glove box and remove the adjust-
ing pins on both sides of the glove box.
DO-IT-YOURSELF MAINTENANCE
2. Remove the protective padding from the
mounting bracket.
3. Remove the mounting bolts with the socket
wrench, and then detach the mounting bracket.
HXD2096
6
17
HXD2097