Changing The Climate Control Air Filter - Hyundai 2006 Tucson Owner's Manual

Table of Contents

Advertisement

G140B01A-AAT
Checking the Air Conditioning Opera-
tion
1. Start the engine and let it run at a fast idle for
several minutes with the air conditioning set
at the maximum cold setting.
2. If the air coming out of the in-dash vents is
not cold, have the air conditioning system
inspected by your Hyundai dealer.
!
CAUTION:
Running the air conditioning system for
extended periods of time with a low refrig-
erant level may damage the compressor.
G140C01A-AAT
Lubrication
To lubricate the compressor and the seals in the
system, the air conditioning should be run for at
least 10 minutes each week. This is particularly
important during cool weather when the air
conditioning system is not otherwise in use.
G140D02A-AAT
Checking the Compressor Drive Belt
DOHC CVVT
V6
Water Pump Pulley
Power steering
Auto
tensioner
0.2~0.24 in.
(5~6 mm)
Alternator
Alternator Pulley
Eng.pulley
Crankshaft Pulley
When the air conditioning is being used regu-
larly, the compressor drive belt tension should
be checked at least once a month with the
engine turned off.
To check the drive belt tension, press down on
the belt halfway between the engine crankshaft
and compressor pulleys. Pressing with your
finger, you should not be able to deflect this belt
anymore than 1/3 of an inch. If the belt is too
loose, have it adjusted by your Hyundai dealer.
DO-IT-YOURSELF MAINTENANCE
CHANGING THE CLIMATE CON-
TROL AIR FILTER
B145A03JM-GAT
(For Evaporator and Blower Unit)
(If Installed)
The climate control air filter is located in front of
the evaporator unit behind the glove box.
It helps to decrease the amount of pollutants
entering the car.
COMP
G190A01GK
1. Open the glove box and remove the support
strap through the hole.
6
17
HJM2133

Advertisement

Table of Contents
loading

Table of Contents