Directions For Use (Patient); Electrode Setup - Empi Continuum User Manual

Directions for Use (Patient)

Electrode Setup

10
1. Make sure unit is turned off and lead wires are
disconnected before and after treatment.
2. Clean electrode application area with soap and
water. Rinse and dry. Electrode should only be
applied to intact, clean skin (e.g., not over open
wounds, lesions, infected, or inflamed areas).
3. With electrodes still on liner, connect lead wire
from unit electrode connector. No bare metal
should be visible.
4. Remove electrode from liner by grasping the
edge of the electrode and peeling it off the
liner. Retain liner for storage.
5. Place the electrode on exact skin location by
applying the center of the electrode first and
smoothing down to electrode edges.
6. Attach lead wire to unit and begin treatment.
7. After treatment, turn unit off.
8. Remove electrode from skin by peeling
electrode edge.
Continuum User's Manual