Hummer 2009 H3 Owner's Manual page 307

3. The hoist end of the extension
tool (I) must connect to the
hoist shaft (E). The hoist end of
the extension tool is used to
lower the spare tire.
Do not use the chiseled end of
the wheel wrench.
4. Turn the wheel wrench (G)
counterclockwise to lower
the spare tire (A) to the ground.
Continue to turn the wheel
wrench (G) until the spare tire (A)
can be pulled from under the
vehicle.
If the spare tire does not lower
to the ground, the secondary
latch is engaged. See Secondary
Latch System (H3T) on
page 5-76.
5. Pull the spare tire towards you.
6. Tilt the tire, with slack in the
cable, to access the tire/wheel
retainer (B).
Service and Appearance Care
7. Separate the retainer from the
guide pin by sliding the retainer
up the pin while pressing down
on the latch. When the retainer is
separated from the guide pin,
tilt the retainer and pull it through
the center of the wheel along
with the cable and guide pin.
8. Put the spare tire near the
flat tire.
5-71