Hummer 2009 H3 Owner's Manual page 176

3-58 Instrument Panel
Using the Digit Dial Command
g
1. Press and release
system responds with "Ready"
followed by a tone.
2. Say "Digit Dial". The system
responds with "Digit dial
using <phone name>, please say
the first digit to dial" followed
by a tone.
3. Say the digits to be dialed one at
a time. Following each digit, the
system will repeat back the
digit it heard followed by a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say "Dial".
The system responds with "OK,
Dialing" and dials the number.
•
If an unwanted number
is recognized by the system,
say "Clear" at any time to
clear the last number.
•
To hear all of the numbers
recognized by the system, say
. The
"Verify" at any time and the
system will repeat them.
Using the Call Command
1. Press and hold
two seconds. The system
responds with "Ready"
followed by a tone.
2. Say "Call". The system responds
with "Call using <phone name>.
Please say the name tag"
followed by a tone.
3. Say the name tag of the person
to call.
•
If the system clearly
recognizes the name tag it
responds with "OK, calling,
<name tag>" and dials
the number.
•
If the system is unsure it
recognizes the right name tag,
it confirms the name tag
followed by a tone. If
the name tag is correct, say
"Yes". The system responds
g
for
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
1. Press and release
2. After the tone, say "Re-dial". The
Once connected, the person called
will be heard through the audio
speakers.
with "OK, calling, <name
tag>" and dials the number. If
the name tag is not correct,
say "No". The system will ask
for the name tag to be
re-entered.
g
. The
system responds with "Ready"
followed by a tone.
system responds with "Re-dial
using <phone name>" and
dials the last number called from
the connected Bluetooth
phone.