GMC 2010 Acadia Owner's Manual page 179
Hide thumbs
Also See for 2010 Acadia:
- Owner's manual (80 pages) ,
- Brochure (28 pages) ,
- Owner's manual (458 pages)
Table of Contents
Advertisement
7. Firmly press and release the
Learn or Smart button. After
you press this button, you will
have 30 seconds to complete
Step 8.
8. Immediately return to the
vehicle. Firmly press and hold
the Universal Home Remote
button, selected in Step 3 to
control the garage door, for
two seconds, and then release
it. If the garage door does not
move, press and hold the
same button a second time for
two seconds, and then release
it. Again, if the door does not
move, press and hold the
same button a third time for
two seconds, and then release.
The Universal Home Remote
should now activate the
garage door.
To program the remaining
two Universal Home Remote
buttons, begin with Step 2 of
Programming the Universal Home
Remote System. Do not repeat
Step 1, as this will erase all
previous programming from the
Universal Home Remote buttons.
Gate Operator and Canadian
Programming
If you have questions or need
help programming the Universal
Home Remote System, call
1-800-355-3515 or go to
www.homelink.com.
Canadian radio-frequency laws
require transmitter signals to time
out or quit after several seconds
of transmission. This may not be
long enough for Universal Home
Remote to pick up the signal during
programming. Similarly, some U.S.
gate operators are manufactured to
time out in the same manner.
Instruments and Controls
If you live in Canada, or you are
having difficulty programming a
gate operator or garage door
opener by using the Programming
Universal Home Remote
procedures, regardless of where
you live, replace Step 3 under
Programming Universal Home
Remote with the following:
Continue to press and hold the
Universal Home Remote button
while you press and release
every two seconds (cycle) the
hand-held transmitter button until
the frequency signal has been
successfully accepted by the
Universal Home Remote.
The Universal Home Remote
indicator light will flash slowly at
first and then rapidly. Proceed
with Step 4 under Programming
Universal Home Remote to
complete the training procedure.
5-55
Advertisement
Table of Contents
