Roland BK-5 Service Notes page 30

Jan. 2012
4. Switch pedal / Expression pedal check
The display shows:
1. Connect the DP-8 to the BK-5 PEDAL- HOLD input .
2. Verify that the display shows "Hold: OFF".
3. Press the DP-8 Pedal and verify that the display shows "Hold: ON".
4. Release the DP-8 Pedal and make sure the display shows "Hold: OFF OK".
5. Connect the DP-8 to BK-5 PEDAL - SWITCH/EXPRESSION input.
6. Verify that the display shows "Switch: OFF".
7. Press the DP-8 Pedal and verify that the display shows "Switch: ON".
8. Release the DP-8 Pedal and make sure the display shows "Switch: OFF OK".
9. Remove the DP-8 Pedal and connect the EV-5 pedal to BK-5 PEDAL SWITCH/EXPRESSION input.
10. Move the EV-5 Pedal and verify that the value shown gradually changes from 000 (minimum) to 127 (maximum).
When both extreme values are reached the display will show OK.
11. Press [START/STOP] button to go to next test.
3
DP-8
Put selector in
SWITCH position
DP-8
Put selector in
SWITCH position
EV-5