Table of Contents
Advertisement
Headlamp High/Low-Beam Changer
23
(Headlamp High/Low-Beam Changer): To
change the headlamps from low to high beam, pull the
multifunction lever all the way toward you. Then
release it.
Flash-to-Pass
This feature allows you to use your high-beam
headlamps to signal a driver in front of you that you
want to pass. It works even if your headlamps are off.
To use it, pull the turn signal lever toward you, but not so
far that you hear it click.
If your headlamps are off or on low-beam, your
high-beam headlamps will turn on and stay on as long
as you hold the lever toward you and the high-beam
indicator on the instrument panel will come on. Release
the lever to turn the high-beam headlamps off.
When the high beams are
on, this light on the
instrument panel cluster
also will be on.
Windshield Wipers
You control the windshield wipers by turning the band
with the wiper symbol on it.
8
(Mist): For a single wiping cycle, turn the band to
mist. Hold it there until the wipers start, then let go. The
wipers will stop after one wipe. If you want more
wipes, hold the band on mist longer.
Delay: You can set the wiper speed for a long or short
delay between wipes. This can be very useful in light rain
or snow. Turn the band to choose the delay time. The
closer to the top of the lever, the shorter the delay.
d
(Low Speed): For steady wiping at low speed,
turn the band away from you to the first solid band past
the delay settings. position. For high-speed wiping,
turn the band further, to the second solid band past the
delay settings. To stop the wipers, move the band to
off position.
a
(High Speed): For high-speed wiping, turn the
band further, to the second solid band past the
delay settings.
9
(Off): To stop the wipers, move the band to off.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
worn or damaged, get new blades or blade inserts.
3-9
Advertisement
Chapters
Table of Contents
