Front Turn Signal and Parking
Lamps
1. Remove the two screws at the inside edge of the
parking/turn signal lamp assembly.
2. Remove the lamp assembly.
4. Pull the socket out of the lamp assembly.
5. Pull the bulb from the socket.
6. Gently push the new bulb into the socket.
7. Put the socket back into the lamp assembly and
turn it clockwise until it locks.
8. Put the parking/turn signal lamp assembly back into
the vehicle and tighten the screws.
5-54
3. Squeeze the tab
on the side of the lamp
socket while turning
the socket
counterclockwise.
Taillamps, Turn Signal, Stoplamps
and Back-up Lamps
1. Open the rear door. See Rear Doors on page 2-11
for more information.
2. Remove the
two screws
from behind
the door.