GMC 1995 Jimmy Owner's Manual page 146

To PIay A Cassette
Your tape player is built to work best with tapes that are 30 to 45 minutes
long on each side. Tapes longer than that are so thin they may not work well
in this player.
Once the tape is playing, use the upper and lower knobs for volume, balance
and fade just as you do for the radio. A lighted arrow shows which direction
the tape is being played.
CrO2
-
The CrO2 button lets you set the system for the type of cassette
being used. If you are using chrome or metal tapes, push the 0 2 button in.
FWD
-
To rapidly advance the tape, press
4
or
b
in the direction that the
amber arrow points and the tape will rapidly go forward until you press the
STOP-EJECT button lightly.
REV - To rapidly reverse the tape, press
4
or
b
in the opposite direction
that the amber arrow points and the tape will rapidly reverse until you press
the STOP-EJECT button lightly.
SEARCH
-
Press the SEARCH button to the recessed position.
Press
b
to go to the beginning of the next selection.
Press
4
and the tape will reverse to the beginning
of
the current selection.
PROGRAM
-
To go from one side of the tape to the other, press the
PWR-VOL-PROG-RCL knob.
STOP- EJECT
-
To remove the tape or stop the tape and switch to radio,
press the STOP-EJECT button.
If "Cln" (Clean) appears on the display when you insert your cassette tape,
your cassette player needs to be cleaned. It will still play cassette tapes but it
should be cleaned to prevent damage to your cassette tapes and the cassette
tape player. See "Care of Your Cassette Tape Player" later in this section.
After you have cleaned the cassette tape player, press and hold EJECT for
5
seconds to reset the the "Cln" indicator. The radio will display
"-
-
-"
to
show the clean feature has been reset.
Your Delco system may be able to receive C-QUAM@ stereo broadcasts.
Many AM stations around the country use C-QUAM@ to produce stereo,
though some do not. C-QUAM@ is a re istered trademark of Motorola Inc.
If your Delco system can get C-QUAM signals, your STEREO light will
come on when you are receiving stereo.
%
3-12