Anti-Scan Feature; Unlocking And Locking The Doors And Liftgate Using Keyless Entry; Autolock - Ford 2005 Freestyle Owner's Manual

Locks and Security
5. The doors will again lock then unlock to confirm that your personal
keycode has been programmed to the module.
Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory set code will work even if you have set your own personal
code.
Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds, press the 1 • 2 on the keypad and release.
3. Press and hold the 1 • 2 for two seconds. This must be done within
five seconds of completing Step 2.
Your personal code is now erased and only the factory set 5–digit code
will work.

Anti-scan feature

If the wrong code has been entered 7 times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the UNLOCK
control on the remote entry transmitter.
• the ignition is turned to the 3 (RUN) position.

Unlocking and locking the doors and liftgate using keyless entry

To unlock the driver's door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and liftgate, press the 3 • 4 control within five
seconds.
To lock all doors and liftgate, press the 7 • 8 and the 9 • 0 at the
same time. Note: The driver's door must be closed. You do not need to
enter the keypad code first.

Autolock

The autolock feature will lock all the doors and liftgate when:
• all the doors and liftgate are closed,
99
2005 Freestyle (219)
Owners Guide (post-2002-fmt)
USA (fus)