Table of Contents
Advertisement
Switching the output
video resolution
Use the procedure below to switch the output
video resolution from the various video output
terminals.
Press RESOLUTION e/r.
• The current output video resolution setting is
displayed on the player's front panel display.
To switch the output video resolution, press
RESOLUTION e/r again.
• The output video resolution setting can also be
switched by selecting Resolution from the
Initial Setup menu (page 39).
Caution
• On some devices (TV, AV receiver or amplifier,
etc.), the video or audio may not be output
properly when the resolution is switched. If this
happens, use RESOLUTION to set a resolution
at which the video and audio are properly
output.
• When video signals are being output with a
resolution of 4K/24p, 4K, 1080/50i, 1080/50p,
720/50p, 1080/24p, 1080/60i, 1080/60p or
720/60p from the HDMI OUT terminals, the
picture may be output with an aspect ratio of
16:9, even if the TV Screen is set to 4:3
(Standard).
• The picture may not be displayed for a while
when the resolution is switched.
• When the connected device supports 3D and if
a 3D Disc is played back, the 3D output is
prioritized for output, regardless of the
resolution settings. Also, switching of
resolution may not be possible while the 3D
contents are playing.
• When Auto is selected, the picture is output at
60 frames/second if your TV is not compatible
with 1080/24p signals.
• When 4K, 4K/24p, 1080/24p or Source Direct is
selected, the signals are output as such, even if
your TV is not compatible with 4K, 4K/24p or
1080/24p signals. If the picture is not displayed
properly, use RESOLUTION e/r to set an
output video resolution at which the video and
audio signals are properly output.
• When the Resolution is set to Auto and if the
television set in use supports 4K or 4K/24p
output, then the output is made in 4K or 4K/
24p. If the connected television set does not
support 4K or 4K/24p, then the output is made
with a recommended resolution other than 4K.
• When the Resolution is set to Auto, 1080p, 4K or
4K/24p and if the resolution of output from the
HDMI is 1080p, 4K or 4K/24p, then output may
not occur depending on the HDMI cable in use.
• There are resolutions that cannot be output
depending on the television set in use.
• When the HDMI Mode is set to Pure Audio, the
1080p60, 4K/60p or 4K/24p, output will not
occur even if the resolution is set to Auto or
1080p, 4K or 4K/24p. The output will be
delivered with a resolution of 1080/60i, 1080/
24p or the like, depending on the resolution of
the source and the connected television set.
• For Dolby Vision output, the optimal resolution
is automatically set for video content.
• When playing an UHD-BD disc, if the
connected HDMI device does not support
HDCP 2.2, the video cannot be output in 4K or
4K24p resolution even if Auto, 4K24p, 4K or
Source Direct is selected. Also, depending on
the HDMI device, the HDMI or HDCP setting
may be required. Check the operating
instructions of the connected device.
03
25
En
Advertisement
Table of Contents
