Exhaust Hose Installation - Sylvania SYL-08PE Owner's Manual

INSTALLATION INSTRUCTIONS
Fig.18a
Hook
Expansion plug
position
Adaptor A
Adaptor
cap
13

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed
in accordance with the usage mode.
Fig.18b
COOL mode
FAN or DEHUMIDIIFY mode
1. Install the window Exhaust adaptor B onto the exhaust
hose as shown in Fig.18a. or Fig.18b. Refer to the previous
pages for window kit installation.
2. Place the Exhaust hose over against the air outlet opening
Fig.19
hook(See Fig.19) and flat the other end(See Fig.20) for
quick installation.
The exhaust hose can be installed into the wall
(Not applicable to the units without adaptor A, expansion
plugs and wooden screws of Accessories ).
1. Prepare a hole in the wall. Install the wall Exhaust adaptor A
onto the wall(outside) by using 4 expansion plugs and
wooden screws, be sure to fix thoroughly. (See Fig.21)
2. Attach the "Exhaust hose" to wall Exhaust adaptor A.
Note:
Fig.20
Cover the hole using the adaptor cap when not in use.
The duct can be compressed or extended moderately
according to the installation requirement, but it is
desirable to keep the duct length to a minimum.
IMPORTANT:
D O
max 3.94ft
min 0.98ft
Fig.21
Fig.22
NOT OVER BEND THE EXHAUST HOSE
Install
Remove
(SEE Fig.22)