Care And Maintenance - Sylvania SYL-08PE Owner's Manual

CARE AND MAINTENANCE

Air filter
(slide out)
Remove the
screw and
take the air
inlet grille
down
Fig.27
Remove the air filter
out from the grille
Band
15
CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
Fig.26 manufacture or its agency.
1. Air filter
- Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust.
- Removal
This unit has two filters. Grasp the upper filter tab(Fig.26),
pull the filter out then up . Remove the lower filter by
loosening the screw, taking down the air inlet grille, then
removing the air filter as shown in Fig.27 & 28.
- Cleaning
Wash the air filter by immersing it gently in warm water
(about 40 C/104 F) with a neutral detergent. Rinse the filter
and dry it in a shady place.
- Mounting
Insert the upper air filter from upward after cleaning, attach
the lower air filter on the air inlet grille, then install the grille
by using the screw.
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean
Fig.28
the unit enclosure. Finished by a dry clean cloth.
Power cord
3. Unit idle for a long time
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet . Place the open end of the hose
directly over the drain area in your basement floor
(See Fig.23 & 24).
- Remove the plug from the bottom drain outlet, all the water
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
Fig.29
forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape(Fig.29). Remove the batteries from
the remote controller.
- Clean the air filter and reinstall it.
- Unscrew the exhaust hose to the right or left and pull out
for uninstallation(Fig.30), keep it safety, and cover the
window(wall) hole with the adaptor cap.
Fig.30
, ,
, ,
,,
O O
in the bottom tray w drain out (See Fig.25). ill
,,