Beko DUT25401W User Manual page 43

Opening of the detergent dispenser lid is prevented during washing. >>> Place the
•
dishes in a way that will not prevent the detergent dispenser lid from opening and the
water going into the machine from impellers.
Detergent is stored under unsuitable conditions. >>> If you are using powder
•
detergent, do not store the detergent package in humid places. Keep it in a closed
container if possible. For ease-of-storing, we recommend you to use tablet
detergents.
Wash Arm holes are clogged. >>> Lower and upper Wash Arm holes might be clogged
•
with food remnants such as lemon pips. Clean the Wash Arm regularly as illustrated in
section "Cleaning and Care".
Decorations and ornaments on kitchen utensils are being erased.
C
Decorated glasses and decorated luster porcelains are not suitable for
washing in the dishwasher. Manufacturers of glassware and porcelain
tableware items do not recommend washing such kitchen utensils in the
dishwashers either.
Dishes are scratched.
C
Kitchen utensils that contains or are made of aluminum should not be washed
in dishwasher.
Salt leakage exists. >>> Pay attention not to spill salt around the salt filling hole while
•
adding salt. Spilled salt can cause scratches. Make sure that the salt reservoir lid is
tightly closed after finishing the filling process. Run the prewash program to remove
the salt that spilled inside the machine. Since the salt granules that will remain under
the lid will dissolve during prewash, causing the lid loosen, check the lid once again at
the end of the program.
Water hardness setting is low or salt level is insufficient >>> Measure the hardness
•
of the supply water appropriately and check the water hardness setting.
Dishes are not placed orderly in the machine. >>> When placing the glasses and
•
other glassware into the basket lean them not against other dishes but the edges
or racks of the basket or the glass support wire. Striking of the glasses to each other
or to other dishes due to the impact of water during washing can cause breaks, or
scratches on their surfaces.
A smear remains on glasses that resembles milk stain which can not be
removed when wiped by hand. A bluish / rainbow appearance occurs when
the glass is pointed to light.
Excessive rinse aid is used. >>>Lower rinse aid setting. Clean the spilled rinse aid
•
when adding rinse aid.
Corrosion has occurred on glass due to soft water. >>> Measure the hardness of the
•
supply water appropriately and check the water hardness setting. If your supply water
is soft (<15 gpg), do not use salt. Choose programs that wash in higher temperatures
(140-149 degress Fahrenheit). You can also use glass protective detergents that are
commercially available.
40
USA