Base Station Overview - Amplicomms BigTel 1580 User Manual

1.2.

Base Station Overview

11
1. Press the Page on the base station to page your handset. It will ring
for approximately 60 seconds. Press and hold
about five seconds, the base station will enter into registration mode and is
ready for handset registration.
2. VOLUME UP
Increase (+) speaker volume during message playback.
3. 7-SEG LED DISPLAY
0F-> -- When answering machine is OFF
-- When answering machine is OFF and no new TAM messages
received
0n->XX When answering machine is ON where XX is number of
messages in TAM memory
00 Steadily ON: No voice messages in TAM
XX Flash: There are XX new voice messages received where XX is
from 01 to 59
ZZ Steadily ON: There are ZZ old voice messages kept in the
TAM memory (no new voice messages)
XX/FF Flash XX alternatively with FF: There are XX new voice messages
received where XX is from 01 to 59 and the TAM memory is full
FF Flash FF: TAM memory is full and there are no new messages,
only old messages are kept in TAM memory
- -/XX Flash XX alternatively with - -: Time is not set and there are
XX new voice messages received where XX is from 01 to 59
- - Flash - -: Time is not set and there are old voice messages
kept in the TAM memory only (no new voice messages)
XX Steadily ON: Playing the current XX incoming old message
A1/A2 Steadily ON: Playing the current outgoing message (OGM) where
A1 is the Answer & Record OGM and A2 is the Answer Only OGM
XX/An Flash XX alternatively with An: XX new incoming message is
now recording. An denotes that the incoming message
recording is in progress
rA Flash: Remote access is in progress
LX Steadily ON: Indicate the current volume level where X is
from 1 to 8 (non-cyclic)
CA Steadily ON: when the base unit is in conversation mode
10
12
4
7
3
9
6
8
5
2
6
on the base station for
1