Clock - Chevrolet 2011 Traverse Owner's Manual

5-8 Instruments and Controls
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone is
set to the variance zone in which
the vehicle is located. See
Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press the vehicle information
button until PRESS
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE
for a few seconds when the
calibration is complete. The DIC
display will then return to the
previous menu.

Clock

To adjust the time and date:
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN, then
TO
press
2. Press
MM, DD, YYYY (hour, minute,
month, day, and year).
, to turn the radio on.
to display HR, MIN,
3. Press the pushbutton located
under any one of the labels to be
changed.
4. To increase the time or date, do
one of the following:
Press the pushbutton below
the selected label.
Press SEEK.
Press FWD.
Turn clockwise.
5. To decrease the time or date, do
one of the following:
Press SEEK.
Press REV.
Turn counter clockwise.