LED Lighting FRT5 V2 Installation Manual

FRT5 V2
INSTALLATION MANUAL
Class III
•
The protection against electric shock is based on the use of a safety extra low voltage power supply (SELV).
•
No provision for earthing is provided.

Installation Requirements

•
This fixture must be supplied with SELV voltage that does not exceed 50VAC and is normally 24V. Follow the
PSU parameters for input power from the socket.
•
Connect to an individual branch circuit.
•
LLSA ensures a 2 kV surge protection on our PSU, anything out of this range will void warranty provided.
•
Improper installation might cause an electric shock accident.
•
Use an authorized electrical professionals to do the installation, repair and maintenance of the light fixture.
•
Cut off the power before and during installation, maintenance and repair of the light fixture.
•
Do not install the light fixture on top of or near hot objects to avoid damage. (For example hot gas pipes, exhaust
funnels or stoves)
•
Do not install the light fixture in a damp area or where liquid leakage is potential.
•
Make sure no fire regulations are violated.
•
Do not cover the lamp with a heat insulating material.
•
Do not look directly at the light fixture for a long period of time to avoid sight damage.
•
The use of third party replacement parts is not recommended by the manufacturer for it will lead to warranty void.
•
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a
similar qualified person.

Cleaning and Maintenance of Enclosure

•
Do not use solvent-based cleaning agents, this will cause cracks to form in the plastic diffuser covers.
•
Clean with a damp cloth and silicone-based cleaning agent. (Such as Mr Min)